Hey all, I have a maintenance window this weekend to upgrade our 6248s to 6332-UP FIs in one of our domains. I have researched the upgrade whitepaper, and have opened a case with TAC, but am still a little nervous since I haven't done this before. ...
Forum Posts
Hopefully this is an easy question. I tried to add a 10-gig link to a fabric portchannel between a 2208XP IOM and a 6248 FI, but found I had some layer 1 issues and had to back out. I unplugged the connection and disabled the port, but am still get...
i need some info if the UCSC-SAS9300-8E can have the functionality to as as an external RAID controller for external RAID enclosure?
Hi Community I have found issue wherein my hard disk state is "Moderately fault" and I've decided to RMA it . My problem now is that when the I've install the RMA HDD the state was "unconfigured good" and when I've tried to ping the Hypervisor no res...
CIMC 1.5.4 on C260M2;CIMC https to page;SSL received a malformed Server Key Exchange handshake message. (Error code: ssl_error_rx_malformed_server_key_exch) Failed in Firefox 27.0.1 works in IE 8.0
Hi, I don't know where else to go. I have two C220 M3 servers. I have tried to lauch the KVM with multiple computers. At first it started with Java Issues. So I turned off all security features in Java and IE. So I can now download the KVM applicatio...
Hello,I'm actually from the Collaboration site. Now I have to install two new C220M5SX without VMWare. First I installed the latest BIOS version 4.0.4c via Host Upgrade utility. Here all the NIC drivers were updated. After that I took the current cu...
Resolved! UCS C220 Raid configuration change
Hello, I would like to change RAID configuration from 0 to 5 in a server, is there any hope for me to do it without losing data ?Thanks in advance
Hi, I'm very newbie to the Cisco Fabric Interconnect system and I've been searching how to configure a FI port with a VLAN in access mode so that it can be used as a second uplink to a Nexus 5K. I already configured the Nexus port, but I still can't ...
We are upgrading our storage device and need to connect a 2nd iSCSI device while using different vlans. The original device was not set up correctly as it used the same vlan for both A and B. Is it possible to have another device directly connected ...
Resolved! Visio Stencils for VIC 1387
where can i find stencils for VIC 1387 ?
Hi, I am trying to understand the UCS, When I boot the server (Chassis-1 Server-2) from UCS, & KVM to it, then Reset it, it can boot from SAN, but it get allocated IP address from somewhere as shown in attached picture.1) Where this IP address is com...
Resolved! UCS: Adapter 1/1/1 is unreachable
Hi,I am receiving the attached fault from UCS, basically it saying that "Adapter 1/1/1 is unreachable"Please advice.Thanks
Is it possible to built cluster of 2 Different Server nodes under the same Hyperflex? For example 3 Server Nodes of HXAF240C-M5SX and 3 Server Nodes of HX-UC-C220M5SX work under same hyperflex?
can someone tell me how i would export the switch configurations of a UCS chassis with 6248 inter connects?
