07-21-2015 04:10 PM - edited 03-01-2019 12:17 PM
Hello Everyone
I am getting an error stating our flexflash is unhealthy after firmware upgrade. Says it is running old firmware. I did not even know we had flexflash on our systems and do not see away to upgrade the firmware. I read that you are supposed to see this in the storage tab but do not see this . How do i resolve this error?
Solved! Go to Solution.
07-17-2018 12:46 PM
Yes the re seating resolved the issue. Complete power cycle and re acknowledgment resolved the issue.
09-24-2020 12:14 AM
Yeah, but hat is not an option on CISCO ASA4110 unit which have the same issue - you cant do that on a ASA4110 unit
FlexFlash Controller 1 on server 1/1 is unhealthy. Reason: Status: FFCH_ERROR_OLD_FIRMWARE_RUNNING
06-21-2016 02:15 PM
This did trick with me. thanks!
06-28-2016 06:09 PM
This worked for me too, with the slight exception that you have to click on the Blade, the Inventory, then the storage tab.
09-21-2016 11:28 AM
Thanks, This resolved my error as well.
Helpful post.
07-28-2017 06:02 AM
This worked for me too
09-13-2021 11:25 AM
This helped to clear the alarm, i don't have FlexCards installed. Thank you
04-27-2018 06:35 AM
I just fixed it by resetting the flex flash controller on the server inventory options
07-17-2018 10:35 PM
Same goes for me, we resolved this issue several times by resetting the flex flash controller.
You just have to be patient: after the reset it takes some minutes after the error disappears.
08-06-2018 05:41 AM
Having similar issue with (UCSB-B200-M4) FlexFlash error below: will resetting wipe out the contents of SDCARD? Will the ESXi Host bootup fine after reset?
08-06-2018 06:55 AM
Reseting the Controller is disruptive as the server looses the connection to the SD cards.
But it will not erase the content of the cards. If you want to delete the cards you have to choose "Format SD Cards".
08-06-2018 08:30 AM
08-06-2018 11:03 AM
08-06-2018 11:23 AM
Error Invalid Size typically indicates a problem with the SD card themselves.
If you were getting a "flexflash controller unresponsive" then a reset would likely resolve this.
08-06-2018 11:49 AM
I have also seen this message when the two SD cards being used are not identical. (Different size, etc). The platform requires that the two cards be identical.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide