what is the version of code running - You can try either below method that should work for you :
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/ts/guide/trouble.html
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/3-1-1/s...
check the below thread to find out more about what caused the issue :
https://community.cisco.com/t5/cisco-bug-discussions/punt-inject-5-drop-punt-cause-punt-cause-policer-drop-packet/td-p/3959555
Hello support
i am not sure iam the one who facing the issue, but i checked same time on mobile i see the same time
i am based at +0:00 BST - around 8 am to 9 am between the community site losing the connection in the middle of my comments, and a...
Looking to deploy in production environment, Default Catalyst 9300 ship with Everest-16.6.3 ED.
what is the difference here - which one got more advantage, i know Everest is the answer, if that is answer Why Fuji ?
as per the matrix its supported :
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst_standalones/b-in-service-software-upgrade-issu.html
what DNAC Version ?
can i run command 'install commit' to resolve this? I
if you like to do traditional ...
what switch model and IOS code running on it ?
does the switch have SVI for VLAN, are you tried using sourcing the same SVI Interface ?
does the switch have any QOS and COPP ?
you can disclose the IP its RFC 1918 address so we can understand end IP y...
Hope you aware that this is cisco community - not GNS3 , may be posting with GNS community get more reply than here.
https://www.gns3.com/community/featured