Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all. I have a CUBE serving a CUCM that's connected to the service provider's SBC. For outgoing calls, I've created two dial peers, one incoming for the CUCM to CUBE leg and one outgoing for the CUBE to SBC leg. These dial peers match everythi...
Hello all! I've just installed a new ISR4321 as a CUBE and connected it with a SIP trunk on a CUCM 11.5, using an MTP. The CUBE connects to the ISP's SBC. The client is able to receive and make incoming and outgoing calls, however, during high cal...
Hello! I have been looking at some of the trace logs of some calls I have made, and I'm not sure how to interpret some of the results. Here is my CUCM call logs trace:
1) 2016/03/23 20:57:19.338|CC|SETUP|130020296|130020297|7050|XXXXXXX7000|XXXXXX...
Take a look at this video that helps to illustrate how the Originate or the Self-Origination BGP attribute operates:https://youtu.be/xa9OfO6i1_M?si=YDU0IX4sqkOuX1eM
The notation of IPvX, where X is the version of the protocol, comes from the actual version number that appears in the "version" field of the IP packet header. Version number 5 was reserved in the 1990s for a now-defunct experimental stream protocol...
Hello all.This video may also be helpful to further understand and illustrate how the Local_PREF attribute is used as a tie-breaker in the BGP Best Path Algorithm.
Thanks to both Roger and Steven for your valuable insight! I will go over these and implement a solution over the next few days. I will let you know of my results and get back to you if I need additional info. Will keep you posted! Thanks again!...
