Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a question regarding the box2box Cube HA. Our customer has a B2b configuration where each cube is connected to one switch on each end and there is direct connection between the cubes via Gigabit Port.
The customer has tried to do a ...
Hello,
Did someone came across such an issue with CUC ntp servce ?
secondary node is not synced with the Ntp server.
Primary node from the cluster is running ok, and is synced, subscriber has as a ntp server cuc publisher node..
I have run the d...
Hello,
I would like to Ask a question.
I have users in the Call pickup group (visual signaling, timer set to 15 seconds) .
If the user A is in Call and another call comes in, the users stated that then immediatelly rings the call on another phone....
Hello,
I have a question about the MS teams direct routing Ca Certificate upgrade.
Is it ok only to create another trustpoint on the cube with
crypto pki trustpoint <trustpoint name>
crypto pki authenticate <trustpoint name>
or are there more step...
Hello,
I have checked the logs on one of the cubes we are using and the following error I have seen there
SIP: (263152) a=framerate attribute, level 1 instance 1 not found.Mar 9 10:43:58.048 mez: //263152/BF96EEBA87F7/SIP/Error/sipSPI_ipip_upd_2833...
as what I have seen in the docu, the redundancy reload is enabled by default, so it is normally not visible. but in our configuration it was disabled. ( so the cubes are working in protected mode ? ) is it save to do it during the day, or it wiill tr...
Hi SJDamme, I have checked the config and found there the no redundancy-reload command on both cubes under voice service voip. I guess this could make troubles there also... If I change the configuration to redundancy-reload under voice service voip ...
Hi Alex, Thank you for the link. Exactly there I have found under the restrictions the mention that cube 1 and cube 2 interfaces should be connected to the same physical switch on each side. Howerever the customer configuration is like I mentioned be...
Hi Roger,
Thank you for the Answer,
that is how we plan it to do, (re-deploy the VMs in another VLan with the same hostnames etc, restore from backup and then update to SU3)
My question was more regarding that HW - BE6H-M5 ( as mantioned from Ton...
