Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm trying to make TCL scrip to copy running config to tftp server but when I use date env I get error.
when I copy this text to tcl I get file is created but without any data
------------------------------------------------------------------...
Hi,
is there any way to make special button at phone to monitor PSTN FXO line under CUCM 11.X
same as CME configuration .
dial-peer voice 8000 pots
description ** Land Line 1 **
destination-pattern 9000
direct-inward-dial
port 0/0/0
forward-d...
Hi,
I have common problem FXO disconnect tone , I'm trying to make custom CPTONE in Jordan after search I found this
information from http://www.3amsystems.com/World_Tone_Database?q=Jordan,Disconnect_tone .
the result give me is ( Frequency/Hz = 420...
Hi,I have a strange problem regarding 7916 side cars.We have setup quite a few already but today we have installed 2 and all of them just come up with the Cisco screen but fail to go any further.any ideas.I think its failing because it can tftp its l...
Hi,
at global config under application it's take action for incoming / outgoing VoIP or pots dial-peer even between local extension under CME so all calls disconnect after long-dur-duration reach.
on the other hand if you remove from application ...
this config at my side .
!trunk group Orange carrier-id **Orange** hunt-scheme sequential both!!trunk group Zain carrier-id **Zain** hunt-scheme sequential both!voice class codec 1 codec preference 1 g711ulaw codec preference 2 g711alaw codec prefere...
Thanks ok I agree with you it’s for incoming and outgoing dial-peer match the problem the restrictions become to all calls not just the dial-peer match same as when you buy it separately under application section .
