Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
With CUPI is it possible to enable the Alternate Greeting / disable the Alternate Greeting.
If so when enabling can you sent the Enabled Until time?
-AO
I am attempting to configure manual (without ACS) TrustSec between a 3560cx and 3850 over a fiber trunk port however none of the normal cts commands appears to be recognized on either platform, nor do mka commands appear to be recognized. Its been a ...
Currently we have dial by name implemented and working sucessfully, however we continually get requests to change it to search by first name THEN last name instead of last, first.Is there a way to change the search order of NameToUser? Or re-map the ...
Is the lens door on the camera open (I know it sounds simple but most common problem I've seen on here)?
If yes what firmware are you running on the phone and what version of UCM do you have it registered to?
Is the other endpoint a 9971 as well?
...
1 - It's not possible to know whether there is other electrical damage to those switches, if there is then any reboot could trigger additional port failures, if there isn't then the switch may continue to run perfectly. There is always the possibilit...
If you are running the SFR have you completely removed the other service modules? (i.e. CX)
I've had ASAs failover when they are still present and not being used.
Also, are both of your SFRs installed and running? If you aren't using SFR services act...
CCX 8.5 admin guide: http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/cust_contact/contact_center/crs/express_8_5/configuration/guide/uccx851ag.pdf
-AOPlease rate useful posts and mark answers as "correct" if applicable.
