Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello
I need a help to fix an fax issue.The DN affected to the fax is configured in a callmanagerIntegrated with a trunk SIP to a NativIP server. we cannot send or receiv a fax .
The fax call flow is PSTN--H323-->ISR---->CUCM----/Trunk SIP/-----Nativ...
hello all i have an issue in a trunk Sip with a unallocated number. the call flow is like that: NativeIP----(0001486821969)---/SIP trunk/-----CUCM----GwVoice-----PSTN. From RTMT the call is rejected by the Trunk SIP CUCM side, with error "unallocated...
hello,
Some finesse agent , after loging cannot get "ready" from "not ready" status.
there is an error message display :"CF_ressources out hors service_".
and traces have two error code
%CCBU_COMMAND_POOL...
hello,
i need a help to understands calls issues between a Callmanager and a SIP trunk,
calls seems busy and disconnect after CANCEL followed a Request Terminated.
here an exemple of trace on RTMT of a call:
2017/10/23 11:13:53.270|CC|SETUP|2663039...
hello,
In VMware environnement, in version system 10.5.2.12901-1, I can't acces to Cisco Unity Connection Administration page.
in the same device, I can acces to the OS Administration and acces to the device by ssh.
The first time the username / pass...
hello Ayodeji thank for your doc. good doc. I have an issue of outbound calls in one of two DP. For IP Phone registered on one DP with Publisher(CM G Pub_Sub) node calls are going fine outbound through a SIP trunk but in all IP Phone registered on th...
Hello Chris
I apply the fax rate 9600 as you suggest but the issue is not resolved.
In the logs from RTMT , in the SIP call process there is an error “488 not acceptable media” between the GvoixISR and the Trunk SIP on CUCM.
Here the trace:
Message D...
Hi
thank for your email.
I check the CSS, it is OK but the situation change, the error message on SIP process indict a codec missmatch.
I must check the region parameters in the Trunk SIP is it correct?
regards
Omar
