Buy or Renew
Buy or Renew
pma1995
Level 2
Level 2
Member since ‎09-30-2004
‎02-12-2026
Awards
No awards available to display
Recent Badges

User Statistics

  • 37 Posts
  • 0 Solutions
  • 159 Helpful votes Given
  • 42 Helpful votes Received
Recent Badges
Reorder
❮
Meraki Community Member
First Discussion
40 Helpful Vote
5 Discussion Posts
5 Helpful Vote
30 Replies
30 Helpful Vote
30 Discussion Posts
25 Helpful Vote
20 Helpful Vote
20 Discussion Posts
15 Helpful Vote
10 Discussion Posts
1 Reply
30 Helpful Vote
1 Accepted Solution
10 Helpful Vote
20 Replies
CCP Member
1 Helpful Vote
10 Replies
5 Replies
Certifications
No certifications available to display

User Activity

TelePresence VGA to DVI cable and conduit

03-02-2010
We have a new CTS-1300 system with a presentation cable which has a VGA connector on the user side and a DVI connector on the codec side.  Currently the room has a 1 1/2 inch conduit installed under the floor between the conference table and codec.  ...

TelePresence VLAN

02-12-2010
We have one Communications Manager cluster to act as our PBX.  We recently purchased a new TelePresence system and a 2nd CM cluster which will be dedicated for the CTS.  The TelePresence SRND states to put the CTS codec in the Voice VLAN. There's no ...

Access Operator Mailbox via telephone keypad

07-23-2008
I am running Untiy Connections on CUCMBE 6.1. I can access the operator mailbox via Unity PCA web page but I cannot access the operator mailbox via the telephone keypad. On my phone, I press the messages button, *, enter 99990 which is the operator...

Presence click to dial with Outlook

02-28-2008
Outlook displays phone numbers without the 91. When I click on an Outlook contact CUPC shows failed conversation. If I add a 91 plus the 10 digit phone number to the contact then click on it the call goes through. I tried adding an Application Dia...

Line selection when going off-hook (outbound call)

09-30-2004
CCM 4.0 will only select line 1 when going off-hook for outbound calls. We chose a different line, for example line 2, as the prime line under the user setting;device association. That did not fix the problem. Any ideas?
Community Statistics
Member Since ‎09-30-2004 11:00 AM
Date Last Visited ‎02-12-2026 09:52 AM
Posts 37
Total Helpful Votes Received 12