Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, So I have a stack of 2 x Catalyst 9300 and 2 x C9300-DNA-E-48= licenses.I'm a bit confused on how to activate these licenses. Everything clear with the old ones, but the new versions, are just RTU ? Thanks,N
Hi all,
I'm setting up a FreeBSD box to be used as NTP server within my network, which most of the time will be a stratum 2 NTP.
While I do have some sync problems between the FreeBSD box and the Stratum 1 (work in progress due to a firewall between ...
Hi all, I do have 3 x AIR-AP3802I-E-K9 and a WS-C3560X-48P with a PS of 1100 W, capable of 802.3at.I can get the APs on the WLC, but they're not broadcasting, and clean air is off. After some troubleshooting, even if I configured the switch interface...
Hi all,
My company just purchased 3 x AIR-AP2802E-E-K9. While booting, all of them are looking for a wireless controller. Since we don't have one, I'm trying to convert one of APs to Mobility Express.
Checking Cisco's documentation for Aironet 2800 (...
Hi all,
I'm trying to find out the difference between AIR-AP2802E-E-K9C and AIR-AP2802E-E-K9. I read a few documents and found out that the "C" comes from configurable but nothing more than that.Do these AP's need an wireless controller to work ?Can ...
Hi @Cisco SE,
Very important to understand it's the client's decision to which AP will roam.
You can only influence this decision using:
802.11r;802.11k;802.11v;you're saying the APs are quite close one to the other, you may want to disable the low...
According to table 10 from https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-switches/data_sheet_c78-728232.html your switch should be able to provide 30W per port for 12 APs.
Check the running-config and look for a...
