Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,When we provision DSPs on Voice Gateways using on Board PVDMs or PVDMs on NMHDV module, how do they get assigned for voice termination or Conf/MTP resources ?Is it dynamic ? Or can I statically define PVDMs exclisively for voice termination...
Hi,I have a situation where I am sending the local US calls in + E 164 (1+10 digits) format but the service provider expects to receive only 10 digits. If I send the calls to him in 11 digits we get a message that, send only 10 digits. How do we over...
Hi ,I recently changed the cluster ID for Callmanager CDR generation under Enterprice parameters -------> CDR cluster ID settings. Even after changing the cluster ID, CDR files generated by one of the Callmanager shows OLD cluster ID. I am running CM...
May be a silly question..I have a Cisco 3845 router used as a toll bypass router connected to a PBX via ISDN PRI trunk. When I do"show call history voice compact " I dont find any call history. How do I enable that ? Is it possible to push all those ...
Thanks Steve.. It is always been confusing to me how can we manually configure the dsps for voice termination or ios based conf bridges.Some time we get "resource unavailabe" messages during the call setup. That is why I thought, is there a way we c...
Hi,We have dedicated publisher,TFTP server and subscribres. In this scenario what should be address of the callmanager in Ekiga configuration ? Does it need to be subscribrer address where SIP end point uses for call processing ? My Ekiga end point ...
Kunal,It worked just fine for perticular Called number. If I want to list all the calls originated from a perticular site, by its Calling number how should I formulate the querry. Can we list all the calls originated by a DID range begins with +55212...
