Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Enghouse QMS call recording server (Version: 7.4.2.20145 ) that uses the Cisco TSP for call control messaging. It quit working after windows updates were applied on 8/10/2020. I reached out to Enghouse support to investigate the issue and t...
Hi All - I've noticed that if i call DID's on my sip trunk and hang up before the other end picks up the other end (my cisco phones) will continue to ring - sometimes for 3-4 ring cycles. You can actually pick up the phone and its just silence. Any c...
I have a SIP trunk from call centric that goes into my lab gear - they appear to be a good sip service due to cost but I'm having some trouble getting calls to route correctly. The call flow is Callcentric.com ITSP (SIP) --> 2811 (acting as cube) -->...
We recently updated to CUCCx 7.01 SR4 and have had a number of scripts exceed the Max Executed Steps defined limit (after aproximately 25 minutes). We didnt have these issues until updating to SR4 - any thoughts?
I'm working to get our CCM 6.x environment connected to our SIP based fax solution. I setup a SIP trunk, route group and route list (pointed numbers at the list) I'm not sure what are the next steps. I'm not so worried about T38 as we're running G711...
So for those of you struggling with poor email delivery and MWI times this is because Cisco is recommending you use the EWS API's which are terrible (and slow). The correct API's to use within the Oath Application process should be Graph API's (EWS w...
Interesting.. I look at our WLC and the Management interface is the dynamic AP interface... same issue though (unable to join Arc/Playbar with sub). I do have a 'service interface' is this what you are talking about?
I am having the same issue, were you ever able to get this working? Sonos discovery works fine, and the ARC plays music just fine as well but will not pair with a sub (same symptom, the Arc (+?). The sub joins the wifi network fine before joining the...
Is it possible that the Windows firewall has somehow been enabled/re-enabled or the allowed connection ports cleared? For default/insecure connection port is 2748, if the TSP is configured for secure connection port is 2749. Windows Firewall was not ...
Wrap up... OK so its works now I've attached the final running config - NOTE this doesnt have outbound working (that will require some more work) but inbound with DID routing works The attached logs'final-debug.log' is the ccsip debug messages & inf...
