Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all; I need to configure ERSPAN on ACI, my sources are on different leafs and the destination server is connected directly to another leaf...is there a way to send the traffic to the server without any ERSPAN encapsulation "like we can do in NX...
Hello all;
I see on the N9k that I can configure PBR as below
set {ip | ipv6} next-hop address1 [address2...] [load-share]
Cisco stated in the documentation ""You can optionally configure this command for next-hop addresses to load balance traffic fo...
Hello;I have a Cisco IP Phone 6941 running SCCP 8.5.4 firmware and I want to upgrade to the latest firmware 9.0.3 and I am trying to upgrade to unsigned image as advised by the release notes but it fails.I got the following error in the phone Display...
The customer has 2 E1 ports in HQ and an IPCC system and want to reserve 15 channels from the first E1 to be always available for IPCC inbound and outbound...is it possible...and if so what should be the GW type "MGCP, H323" and configuration require...
Dear all;I am deploying a UC implemenation for a big customer and I want to verify the below with you and if/how they can be done:CUCIMOC will be deployed for end user; I need to know is it a must to integrate AD with sAMAccount with CUCM or I can in...
Hello;Did you figure out what was the problem? all documents says it is okay to configure it without any need for additional license or the L3 DC...any updates you have?
It is there and the PBX phone rings, but the call drops after 4 secnonds on recovery on timer expiry for T3014 timer as I dont receive connect ack from the PBX.however for call forward all,busy, no answer it works very normally.
