Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have numerous DX80 devices in my environment and they are all on the new CE software, but I get reports that the DX80s begin to flicker and a reboot will fix it for a little while but not permanently. Is there a hareware issue? When I open a TAC ...
I have an HA UCCX environment and I recently experienced the subscriber UCCX showing in Partial Service. I drilled down under UCCX Serviceability > Tools > Control Center Network Services and saw that it was the VOIP Monitor Subsystem in out of serv...
Has anyone experienced issues with the 8831 displaying "Ethernet Disconnected"? I have installed 2 phones in the same location and they both work to begin with and then for some reason go to "Ethernet Disconnected" and will not work again.They are c...
I continually see the 7937 conference phones re-register for no apparent reason and they will drop calls with the display showing CM Down Features Disabled. Once the user hangs up from the call and re-iniates it then the call will start but will dro...
I have tried a 7965 phone and it works in this jack. I have tried the 8831 in another jack and it will not work still shows "ethernet disconnected". I'm cautious about putting another 8831 in this jack since this is the 2nd phone that has been conn...
