Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are migrating from an ASA to Firepower and we're running into an error when configuring NAT. One of our networks is PATed out a secondary IP on the outside interface. That same secondary IP is also used for a couple of static NATs. On the ASA, ...
For interface ACLs, the inspection rules will permit return traffic through the ACL. On a VPN filter, inspection does not appear to have any effect since there is no interface for inspection to be applied. How can a VPN filter be used so that traffi...
We have a service policy that has a "Do not match" ACL to exempt certain traffic. This ACL is followed by a Match ACL for all other traffic. When I test matching traffic on the ASA by using "show service-policy flow..." command I can confirm that t...
I have a small ACI fabric of 2 spines and 4 leaves. Our end-users are on a 3750x stack that is connected to the fabric via statically mapped EPGs and VLANs. The users and servers are all in the same EPG and Bridge Domain with no contracts needed. ...
I upgraded a stack of 3850 switches to 16.1.3 and to my dismay, SmartPort macros are gone! If macros have been depreciated, what's the replacement to statically apply settings to ports that connect to common devices -- switches, routers, phones, des...
To clear this in UCS System Manager go to Equipment -> Chassis -> Chassis (Number) -> Servers -> Choose Server. Then in the workpane go to SEL Logs and click clear at the bottom.
I know this is an old post, but I just encountered the same thing. The fix for me was to change the "Record" drop-down to "Use Phone" and then the "Open File" option under options was no longer grayed out. Makes no sense but it works!
