Dear Expert,I found that when I transfer a call through Intercluster Trunk (ICT) the original caller ID cannot be displayed. The scenario as below: Phone 1 --> CUCM 1 --ICT--> CUCM A --> Phone A. Phone A can see the call is from Phone 1. Then Phone A...
Dear Expert,How many PVDM bundled with VG310? From CCW, I can add VWIC3 T1/E1 module but there is no option for upgrading or adding PVDM. I concern that if I add a 2 ports E1 module. Does it has sufficient PVDM to work? Thanks & regards,Ben
Dear experts,Is there any way to filter the captioned report by CSQ. As I remember the previous version can filter by CSQ but now it seems only have agent for fitler.Thanks & regards,Ben
Dear Experts,I want to install a standalone ELM Server 10.5 on VM. Is it the same ISO of CUCM 10.5? I create the VM by CUCM OVA and boot up with the CUCM 10.5 ISO but there is no option for selecting ELM to install. Is there any special setting in VM...
It depends on your resilience level for choosing one module, two modules or even two routers. For the DSP, it depends on whether you have any transcoding or conferencing requirement. You can use the DSP calculator for calculating how many DSP require...
Hi,
You can refer to below links about the setup in CUCM.
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/200453-Configure-CUCM-Native-Call-Queuing-Featu.html#anc2
You need to have the CU...
Hi Viru,
I think you want to modify the call routing for enabling the incoming calls with the new DID number. Am I correct? As from your existing configuration in VGs, your carrier should sending 4 digits to your VG. If they do the same thing for t...