Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a tricky issue with elevator phones connected to analog ports on a vg350. I configured them for PLAR in CUCM (11.5) and it appears to work well, but many of the devices themselves have been historically programmed to dial certain numbers via ...
Looking for some advice on dial-peer configuration after adding a secondary SIP provider. This is not a redundant ITSP, it's for separate calls.
I've tried creating dial-peer provisioning policies to match destinations by URI and it has worked for in...
Looking for some assistance. I have Expressway 8.7 in the recommended two-legged design except not using NAT since the outside interface is already publicly accessible. I have a valid Cert on exp-e, and a privately created CA cert on exp-c using th...
Long story short - I generated CSRs for tomcat and CallManager certificates then signed them with an OpenSSL CA. Tomcat went well, but CallManager isn't pushing files to the phones. No TFTP (directory, ring tones, etc.). Trust List Update Failed. ...
An Outlook 2010 user schedules Webex meetings but the correct email template is not being used. This does not occur for all users. His invitations begin with "<Host Name> invites..." rather than populating the variable, and the audio dial-in inform...
Sorry for late reply. Must have went to spam. I did open a case and it is not possible to limit the ports since CUCM delivers the SRST config to device, which is the gateway, not ports/protocols dependent on the gateway. Pasting TAC's response below....
Just had the same behavior on 11.5(1)SU6. Tried slowly pressing Y then Enter in case it was a keyboard latency issue, since Ctrl+C would eventually quit the command after a few minutes' wait. Your button mash trick finally got it running for me.admin...
I'm running into the same issue. We have about three thousand analog devices and only a select group of life safety lines should failover to SRST. The device pools are assigned as required but when the VG350 fails over, all fxs ports register to the ...