Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Someone knows If It is possible to connect NIC NC522SFP with Nexus or Catalyst 3750x through Direct Attach Cable (DAC) HP HP BladeSystem c-Class Small Form-Factor Pluggable 3m 10GbE Copper Cable 487655-B2?Thanks
I have a CallManager cluster 8.6 and Cisco Unified Presence server 8.6.
I am using Jabber for windows.
I uploaded the file "cmterm-cupc-dialrule-wizard-0.1.cop.sgn" on CUCM.
However, I don´t know to configure the Application Dial Rules to be used by ...
I have a CallManager cluster version 8.6.2 with two Gateways 2901.
Each Gateway has two PRI E1 (one card VWIC3-2MFT-T1/E1), one card with 64 DSP (PVDM3-64)
and one card with 32 DSP (PVDM3-32).
I also have a Cisco IP Phone 9971.
Can I make video conf...
Hi,I have a IPCC 4.0(3) server (IP: 10.0.1.5) and a Cisco Call Manager 4.1 (IP:10.0.1.2)Some days ago there was an power outage in the office and the IPCC and Call Manager were restarted.IPCC always worked fine, but after power outage CTI ports and C...
Hi,I have a CUCM cluster 7 connected to ISP.through SIP trunkWhen I make a outgoing call from a IP phone through SIP trunk the call is fine but if I forward the IP Phone (forward all) to a external number and I call from PSTN to that forwarded Phone,...
Hi Surat,yes, you will have to download them from cisco.com although you're right because I also can not find the CME files version 10.5.I only can find the file "CME_GUI_10.5". The rest of files I can not find them.I don´t know what happens
Thank you very much for your help,sorry Jaime, but it is the first time I install Jabber.Do I have any configuration on CUCM to enable User Data Service (UDS) or only I have to specify UDS in the jabber-config.xml global configuration file and to upl...
Hi Jaime,I read the Cisco Jabber for Windows 9.0.x Administration Guide I have a doubt.I have a on-premises deployment model. I can see in the document in the section called 8.6.x On-Premises Deployment Architecture that Directory has to be Microsoft...
Hi Chris,thanks a lot for your help.The "transfer" call handler is correctly configured. In my case the Attendant Console Pilot (DN) is 5100 and I configured the Call Handler which is defined to transfer to the extension of Attendant Console with the...
