Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We need to access FTD's outside interface from inside for monitoring and troubleshooting. I've set up dynamic NAT and nated IP differs from outside IP but in the same network. I can access external IPs except FTD's. Packet tracer output Phase: 2
Type...
Trying to enable diagnostic interface on FP 2100 for gathering information over SNMP. The interface itself marked green in FMC and static IP address is set up but neither ICMP or SNMP to this interface are not responding. Management interface itself ...
We're using FTD 2100 with FMC, need to get active RA VPN sessions counter over SNMP.Information I've found is related to ASA and not suitable for FP.Can anybody share useful FP OIDs or point to documentation links?
In endpoints list I see a lot of devices which I don't need to be managed by ISE such as IP phones. Even MAC addresses that coming from telecom providers are listed there. Those devices are not even in our network! Devices takes licenses, why should ...
Hi,I understand your confusing. Try to look at this thread https://community.cisco.com/t5/network-security/fp-diagnostic-interface-setting-up/td-p/4028172
Enabling diagnostic interface it turned out we can use ASA-compatible SNMP mibs. crasSVCNumSessions = 1.3.6.1.4.1.9.9.392.1.3.35.0 is the counter of RA VPN sessions.Thanks for help, it was not so obvious from documentation.
