Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm testing out a vWLC and have set up 4 APs all in FlexConnect, the Controller is at my central site and the APs are located in Branches across countries. Everything is working fine except for this one AP which keeps rebooting. (1602 series).So ...
Hi, Does anyone know a workaround to this limitation? (other than the "management-access" command for VPN connections) Management access to an interface other than the one from which you entered the ASA is not supported. For example, if your manageme...
Hi Everyone, I've been asked to upgrade the IOS Image on our 2921 Router. We currently have IOS version 15.2(3)T1 and a CME version 9.0 running using SIP and Skynny protocols. I have to upgrade it to CME version 10.0 which I understand is embedded i...
Hi Addey, Could you please advise why you added the deny on the ACL? access-list 100 deny ip 192.168.1.0 0.0.0.255 10.0.0.0 0.255.255.255 The only ACL you need for the traffic you want to send over the Tunnel is the crypto ACL, in this case the VP...
Hi Harish, Let me see If I get this correctly, so what you want is that the 10.0.0.0/16 traffic when it's going to 145.230.12/24 gets natted to 47.73.223.250?? Before the traffic tries to leave, can you see the tunnel is up? Thanks,
Hi, The 1850 series has 1GB uplinks and can go up to 1.7Gbps on the 5Ghz range. http://www.cisco.com/c/en/us/products/wireless/aironet-1850-series-access-points/index.html Best Regards,
Hi, I'm not sure about filtering MAC addresses but I believe that you can expose that service doing static NAT to the Public IP and then filter the access to it by putting an ACL in place (like "outside_access_in") and filter which networks you allow...
