About clileikis

clileikis · 05-31-2012

Hi all,Goiing over the Unity Connection release notes: Cisco Unity Connection 8.6(2) Support for Microsoft Office 365Revised 13 April, 2012In Cisco Unity Connection 8.6(2) and later, you can configure Connection to synchronize voice messages in Conne...

clileikis · 05-10-2011

Hi all,Just looking for some clarification on this one. I'm seeing some conflicting advice about setting the DTMF-Relay on SIP Phones registered to CME with a CUE Module. I've read some documentation indicating that rtp-nte RFC2833 is the only dtmf...

clileikis · 12-30-2010

Hi everyone,I'm having an issue with CUCM 8.5 in VMware (Lab environment). I'm able to get it installed without any issues, however after I reboot the server, network connectivity seems to be broken (unable to ping to/from the CUCM VM). I've had no...

clileikis · 11-26-2010

Hi all,I can't seem to get DTMF passing between CUCM 8.0 and Exchange 2010. I've followed the guide posted in the documents section and did the integration. I made the SIP trunk in Call Manager point to the Exchange server using RFC 2833 for DTMF R...

clileikis · 10-20-2015

Hi Raza,Try using the FQDN/Hostname of UCCX when you log into Finesse, not the IP address.HTH,Chris

clileikis · 05-20-2015

Hi Gordon,We've experienced the same issue with 7841's you describe. It's random and would only happen to one or two phones. Factory restoring the phone resolved the issue, we also upgraded to the latest firmware and haven't seen it since, but woul...

clileikis · 05-20-2015

Hi there,The FXS port would provide dial-tone to your fax machine and you would connect directly to the FXS port, no need for the ATA.HTH,Chris

clileikis · 05-15-2015

Hi there,Sounds like the following bug:Call fail when "-" dash is dialed from Corporate Directory on 88X1 phoneCSCuq14595 https://tools.cisco.com/bugsearch/bug/CSCuq14595HTH,Chris

clileikis · 03-09-2015

Hi Peter,I updated my previous post, the G711 bandwidth calculation without the IP headers calculated by a Gatekeeper is 128 for a single call is 128, not 160. Therefore a single G711 call uses 128 and a single G729 call uses 16.HTH,Chris

Member Since	‎04-08-2008 06:56 AM
Date Last Visited	‎08-24-2018 02:02 AM
Posts	559
Total Helpful Votes Received	587

User Statistics

User Activity

Unity Connection Office 365 Single Inbox - 100 Users Limitation

CME/CUE SIP Phones DTMF-Relay

CUCM 8.5 VMware Issue

CUCM 8.0 & Exchange 2010 DTMF Issue

Hi Raza,Try using the FQDN

Hi Gordon,We've experienced

Hi there,The FXS port would

Hi there,Sounds like the

Hi Peter,I updated my