Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI ALL MY codec PTZ cam subnet is 169.254.1.XBosch 172.16.4.X/22for giving the PTZ camera control to the Bosch system . i was trying to config line inter vlan routing which is not happening . is there any way what we can change the subnet of codec ca...
HI All
Cisco 7961 phone is giving wrong time .. the setup is just upgraded fro CUCM 8.6 to 11.5 . after the upgrade only the issue started .
we have around 10 phone of 7961 on site only 1 phone is having the issue . all the phones are running wit...
HI All
unable to register ip phone on cucm 11 .The phone is getting registered in the devices list but on the phone it gives the ext number and moving to services tab and asking to select services .
It is newly installed PUB
screen shot atta...
Hi All
Here is the topology
PC----------Coreswitch-------- and other switch/servers
there ping is going more then 1ms in maximum time
Reply from 192.168.10.254: bytes=32 time=3ms TTL=255Reply from 192.168.10.254: bytes=32 time=8ms TTL=255Repl...
HI Sandeep ,
as advised i have done login page
but the logo is not displaying please can you help
i here attached the file what i have uploaded .The same file i made as tar and uploaded .
Regards
RR
HI Mark
Thank you for the update
Getting the attached error from a sql application server . The SQL team says it is because of the high latency .
And tracert to the server and the switch is <1ms
regards
raja
