Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I wonder if someone can point me the right direction to configure a DSP Farm for an ISR4331 I am setting up for CME.
The command I would have used under the voice card on a G2 is longer supported.
I realise they G3 cards have on-board DSP's, b...
We have a new UCS C200 M2 server that is running ESXi 5.0.0 and will only neg a speed of 100MB - tried connecting it to a GLC-T on a 3750 and also Copper Port on 2960G - same result.Trying to hard set speed to 1000 in vSphere Client produces an error...
Hi,Has anyone tried to configure a WIP310 for use with a UC520? I'd have guessed it should be possible to at least use it as a "third party" sip client?Any help/advice would be great!Regards,Gordon
Hi Manish,
Thanks for this, however, in this case I have a BRI interface, not PRI.
I can enter:
voice-card 0/1 (the BRI card)
But the DSP command is not available.
Regards,
Gordon
From what I have found you need to create a custom cptone with the following settings:
TONE FREQUENCY in Hz CADENCE in seconds
Acceptance tone 400+450 ...
We have been working on a deployment using Meraki AP's and were consistently seeing phones un-registering to CME when trying to make a call.On the back of this document we changed to 5GHz from 2.4GHz and the issue appears to be resolved!Many thanks f...
Hi Frank, I have just resolved this issue by adding the following permissions to the user:Standard CTI Secure ConnectionStandard CTI Allow Control of All DevicesStandard CTI Allow Control of Phones supporting Connected Xfer and confWe are running CUC...
Hi Matt,Thanks for your post - we had the same issue. Upgraded CUCM from 8.5.1 to 8.6.2.Re-installed the new version of TSP and switched to Media Driver, instead of WAVE driver (a working config we had on another system). CTI Ports registered, but ...
