About carl_townshend

carl_townshend · 09-12-2024

Hi guyswe generally use 9300s for top of rack switches and stack them for resiliency, with port channels from the servers to them.with the stacked 9300s, the control plane is the stack master, if something goes wrong we generally lose both switches.T...

carl_townshend · 09-04-2024

Hi AllI would like to do some equal cost load sharing with default routes to 2 different ISPs on my Cisco ASA, these will go out of 2 different interfaces.Is this possible?Would I just create 2 NATs, one for each interface?Cheers

carl_townshend · 08-08-2024

Hi GuysWe have a Cisco VG420 registered to our Webex environment, we have an issue where all the lines show as unregistered other than port 1 on it.Any ideas what this could be?

carl_townshend · 08-07-2024

Hi AllWe want to direct our main number to our receptionist clients in our Webex console, what is the correct way of doing this please?Thanks

carl_townshend · 07-26-2024

Hi AllI have a question about flexible netflow.On our Catalyst 9500 switch we want to send netflow to our collector (whatsup gold)If we want to collect info from a layer 3 vlan, which is the correct config?vlan configuration 126ip flow monitor WUG-NE...

carl_townshend · 07-31-2024

Hi GuysWe ended up using the Algo device, this is working fine for us.

carl_townshend · 07-26-2024

Hi EnesThanks for that, we already have the rest of it configured, its just the L3 vlan bit.So when would we use the vlan configuration part?

carl_townshend · 07-16-2024

HiFrom what I have read, some of the AP models can run in 2 modes, capwap to a controller or URWB mode.If running in URWB mode, how are these set up? in the cloud? or locally on individual access points ?

carl_townshend · 07-15-2024

Hi RichAre these configured locally or do they need a Cisco Wireless LAN controller? what makes them different from normal Cisco Mesh AP's ? I see they do duplication of traffic across multiple bands for resiliency etc ?

carl_townshend · 07-10-2024

Hi Thanks for the responses, what if we wanted to extend multiple vlans using L2TPv3 ? would you need multiple pseudowire classes? any examples?Also VXLAN EVPN was also mentioned, is one better than the other ?

Member Since	‎05-13-2005 03:24 PM
Date Last Visited	‎09-19-2024 03:36 AM
Posts	5,373
Total Helpful Votes Received	211

User Statistics

User Activity

9300s to nexus for top of rack

Default route to 2 different ISPs on Cisco ASA

Lines showing as unregistered on Webex VG420 Gateway

Correct way for directing a main number to receptionist clients?

Flexible netflow on Cat 9300/9500 on L3 vlan interface

Re: FXO for overhead paging Webex-compatible device?

Re: Flexible netflow on Cat 9300/9500 on L3 vlan interface

Re: Cisco Fluidmesh

Re: Cisco Fluidmesh

Re: layer 2 between 2 sites over wires only mpls