Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm attempting to modify an existing content filter that matches on specific keywords in the subject, and auto-encrypts the email. Basically, I'm trying to make it so if a message is from an internal system, and destined for one of our email domains ...
I've read the docs and searched around, and I can't get a definite answer to a question presented to me. If we have the AMP policy enabled, and have it configured to send "Pending Analysis" messages to the quarantine - will the messages be released ...
I have a question about host licensing in CWMS, that's a little unclear from the docs. Our users are synced with CUCM, and most of them are marked "inactive" as most users don't get hosting access. Of the users that are marked "Active", most of the...
I have a Win 10 Pro laptop that's connecting to my ASA, and the OnConnect script doesn't seem to launch. I can look through the event log and see where it downloads the script (and I can run that script at the command prompt, and get the expected re...
I will readily admit I'm still learning the platform I inherited.
I have a Defense Center version 5.4.1.3 virtual appliance, and an ASA 5515-X running sensor code 5.4.0 that I just recently reimaged to get it working properly again:
Sourcefire Li...
I opened a TAC case on this same issue and it was closed, they basically said "A workaround was provided". Like you, I don't have the manpower to contact hundreds of users to manually upgrade their clients. I've reopened the TAC case and involved m...
OK, so if the verdict is received before the 30 minute timeout, then the message is released immediately, otherwise it is released after 30 minutes regardless. Thanks
Yes, I tried both a .BAT and a .CMD file and they both downloaded to that location. The script is very simple, it just restarts a service that requires network connectivity to an on-net server at startup, and never retries if it fails.
@echo off
e...
Is there any update on this? I notice that the 10.5 version has been pulled from download, and there's now an 11.0 version that is in "Limited Deployment". I still don't have any patches from the WSA GUI.
