Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We're running Unity Connection 7.1.3 and we want to integrate that with an NEC 2400 PIX. We have purchased a TIMG unit. Question is very simple: how do I configure the T1 on the NEC? Will it be a CAS using E&M? What about framing and line codin...
Hello,I am trying to fax from a VG224 configured as MGCP. I have a 2821 configured as a H323 CUBE. A Verizon SIP trunk is connected to the 2821. So the fax flow is this: VG224-->H323 CUBE-->SIP-->SIP provider. I can't make it work since the fax call ...
Hello,I have two separate 6.X Presence cluster installed. Each Presence cluster is connected to its own Call Manager cluster. I have set up an intercluster trunk between the two Presence cluster. The trunk is working fine. The Troubleshooter reports ...
Hello,I'm running Call Manager 3.3.2 SPB with a VG200 gateway. The VG200 is running MGCP. We're using 9.@ for our route pattern. The problem is that when a user picks up a phone, dial a 9 (outside access code), they'll get a dial tone (which is norma...
Hello,I am running CM 3.2.2c SPF. I just cannot dial any 7-digit local numbers. It would wait for about 10-15 seconds and then I'd get a busy tone. But if I include 1 and the area code (eventhough I'm dialing within the area code), it works. Long dis...
The way this finally worked for me after many hours of troubleshooting is to:
* uninstall java and asdm. Reboot.
* install Java 7. I am running Java 7 update 71.
* install ASDM from your ASA by https to your ASA.
* use Firefox and https to your AS...
I would always use a dedicated port on the 5K for the peer keepalive. It is such an important link to use an OOB management switch. There is always a possibility of someone unplugging some cables from that switch and guess what? you would never know ...
Hi Gautam,so are you able to get a 1 gig and a 10g working in one sup engine? I can't. I have a 4510 with SUP6E engines. I applied the hw-module uplink mode shared-backplane command, reboot the switch, now I only see 1 port group per sup engine. I ca...
That was my problem as well. Just ran into this issue. Never knew that I had to check the "Media Termination Point" required for MOH to work. Thanks,Vince
Hi,I have an MCS7825i4 server that I use for the ARC Attendant Console. It runs windows 2003 SP2. Question is: where can I download the NIC teaming driver? We installed windows using a regular Windows disk and not the Cisco-supplied OS disk.Thanks.Vi...
