Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently use a CISCO2921/K9 router to connect to my ISP for Internet service. I am replacing that with an ISR4451-X ISP hands off using Local Access Native Single CoS Medium Ethernet. I basically just copied the 2921 config to the 4451. From the 2...
Is it possible for Cisco Jabber, using computer for calls, to provide a dial tone before a user dials a number.
My user is using a wireless headset that connects to PC with USB dongle. Headset provides a setting to allow for dial tone from soft pho...
I currently have Jabber for Windows 11.5 deployed in my on-premise environment. I've noticed this same issue on previous versions as well.
The issue I am having is when a user shares their screen with me. There is a bar at the top of the window that...
I'm trying to edit the CFUR destination for each 4 digit DN to the DNs full 7 digit DID number so when I have a WAN failure, calls will route out Local Gateways through the PSTN. I can edit them each manually (which honestly I'd be done with by now),...
I have run into a few instances when having a user share their screen with me that it can take up to a few minutes before I get the prompt on my computer to view their screen. In my Jabber contacts list I can see their status as Presenting when this ...
I had the same issue with a version of CUCM that was in the list of known fixed releases. Applied the cli sql command to enable SSO and it's working. Thanks for this post!
Yeah, I was wondering if I had the right part, but it just isn't working like it's supposed to. I do have the 8832-POE and it is only providing POE from the switch port, no network connectivity for some reason. Thanks!
