About INEM

INEM · 08-24-2024

Hello Cisco community,I would like to request support from the community, I'm running in a blocking situation where I cannot finish the first setup because I'm blocked in the Setp #11, configuration of the NTP SERVER SETTINGS (Image attached).Every t...

INEM · 04-16-2021

Hello guys, One question, I want to know which country code I must choose to register my AP cisco AIR-CAP3502I-A-K9 on the WLC? The controller was set up to use the following country code:But the AP cannot register. Can someone help me with that? th...

INEM · 01-26-2020

Hi guys, I setup a simpleLAB with ESAv and SMAv. I already configure the ESAv with the following configuration: From VirtualBOX I setup 3 virtual Adapters on Vmnet1 (192.168.202.0/24), Vmnet2 (172.16.0.0/24) and Vmnet3 (172.16.1.0/24). Ex Vmnet2 con...

INEM · 10-09-2018

Hello, I want to perform a POC with iron port, anyone can tell me what requirements I need on a VM to do this type of test? Thanks in advance

INEM · 03-12-2017

Hello folks, I have a cisco ip phone 8865 at home and I want to connect it by VPN to the work telephony system which run asterisk, any idea how to do this, at home I only have a normal router, it is not a cisco router. In my work I have a VPN server...

INEM · 04-17-2021

Yes, This is a vWLC. No, I miss this part : ) Have been enabled 200 Licenses. Problem solved, thanks a lot Leo.

INEM · 04-17-2021

Hello, I upgrade the image and set up the NTP, the problem persist. From Dasboard of WLC: Any ideia to solve the issue? Thanks in advance,Best Regards

INEM · 04-17-2021

Hi Leo,Ok, please see the output of the commands below:(Cisco Controller) >show timeTime............................................. Sat Apr 17 08:03:54 2021Timezone delta................................... 0:0Timezone location.........................

INEM · 06-19-2015

Hi Vivek, The problem is options, i change the sip.conf in asterisk, and the phone work, basically I removed all the options and add only the essential in [general] and the phone work. I think this is a good choice, because now i can add more options...

INEM · 06-17-2015

Hi Wilson, I disabled the authentication in the sip.conf file with command: allowguest=yes And in the SEP.XXX.cnf.xml i remove the password too. And than the Cisco phone apper in the Asterisk with the following error: The SIP phone is th...

Member Since	‎04-23-2011 05:07 AM
Date Last Visited	‎08-31-2024 01:50 PM
Posts	47
Total Helpful Votes Received	10

User Statistics

User Activity

NTP issue inside APIC-EM Configuration Wizard

cisco AIR-CAP3502I-A-K9

ESA with 3 interfaces

Ironport requeriments

Cisco IP Phone 8865 VPN Client support

Re: cisco AIR-CAP3502I-A-K9

Re: cisco AIR-CAP3502I-A-K9

Re: cisco AIR-CAP3502I-A-K9

Hi Vivek, The problem is

Hi Wilson,