About StevieC666

StevieC666 · 10-25-2021

Hi all, I've posed these questions to our Cisco TSA but I'm he's a super busy chappy at present so figured I'd see if I could get an answer here ahead of a reply from him. Basically we have a critical requirement to be able to provide 'basic' VLANs (...

StevieC666 · 09-02-2021

Hi there, I'm hoping somebody could point me in the direction of some documentation that might help explain a few things? Basically we're running a DNAC 2.2.2.3 XL cluster with 9800-80 WLCs within one Fabric site with 1600 9130ax APs, 200+ 9300 switc...

StevieC666 · 01-16-2021

Hi all, I'm seeking views/guidance/advice on the importance of maintaining version alignment across the components that comprise the SDA solution. We're running DNA 1.3.3.6 on a three node XL cluster with ISE 2.6 patch 6 across two physical servers,...

StevieC666 · 06-14-2020

Hi all, long time reader asking first question. Be kind!  In the post : https://community.cisco.com/t5/networking-documents/vlans-used-in-cisco-dna-center-software-defined-access-solution/ta-p/3945667 it says: VLANs 3001-3500 - Used for Border Upli...

StevieC666 · 06-04-2020

Hi all,I need to swap out two x 1Gb 48port SFP line cards with two x 1Gb 48port RJ45 line cards. The chassis in question is the sole point of connectivity for our DNAC cluster, hopefully one day DNAC will evolve to allowing location of at least one c...

StevieC666 · 10-26-2021

Thanks for the reply, everyday is a school day I can confirm that I was talking about the latter scenario where we want the flexibility of having the SVI for a given network not configured on a fabric edge but rather a device that's an endpoint or ...

StevieC666 · 05-26-2021

We've got six C9400s out there in our campus setups with over 300 C93k & C36k switches hanging off them. Each campus site has two border nodes. We've not connected the FEs which also double as inters together, they only have uplink connections to th...

StevieC666 · 05-11-2021

Hi Rob,We're working through a migration to SDA at the moment, we're essentially going from a single VRF to 5 VNs and of course we face the challenge that things can't be done at the speed to thought so we've needed to leverage co-existance in the fo...

StevieC666 · 03-03-2021

No problem, yes we're using the Closed Auth template. We've a load of other types of FE connected things that sadly we have to manually set the port config via GUI then CLI but fortunately phones just worked

StevieC666 · 03-03-2021

Hi DM, I've just grabbed screenshots of both the IP Pool/VN and auth result settings. I can't insert them on my mobile for so e reason however. I can confirm that the voice type is set in the VN setup and in the auth result both Security Group and Vo...

Member Since	‎05-13-2019 04:01 AM
Date Last Visited	‎08-11-2022 02:16 AM
Posts	25
Total Helpful Votes Received	25

User Statistics

User Activity

L2VNI SW/HW Compatibility

WLC Provision Triggers

SDA Compatibility Matrix, recommended vs supported

SDA Reserved VLAN IDs

c9407 Line Card Swap, reload required?

Re: L2VNI SW/HW Compatibility

Re: Intermediate node deployment

Re: SD-Access L2 Handoff query

Re: SDA Default Voice VLAN

Re: SDA Default Voice VLAN