Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am planning to migrate BE5K to BE6K and going to use COBRAS Export for unity connection migration.What part of the Connection database is not exported by COBRAS Export and I will have to create manually? CUCM/Unity Connection ver - 8.6.2COBRAS Expo...
I am going to install ASA5525-X Firewall in HA mode and both have Software IPS modules and I was wondering how the management IP address will be configured in HA mode. Is both IPS will have same management IP address?I looking for some sample config ...
I have 2 MGCP gateways and each have 1 PRI. These PRIs are under same Route Group. If my primary PRI fails then calls are not routed off of 2nd PRI, but calls routed off of next Route Group which is my backup location.Following Service Parameters are...
I have agent answering calls for Multiple Application (Single CSQ). They see description as Route point XXXX in there CAD for that call. Is there any way I can change that description so they can see call is for which application?I would like to see ...
Thanks for info."Make Call" button is disable in UCCX CAD when Agents are talking. Is there way to make that button enable so Agents can make second call from CAD.
After using this solution, when I press message button I am getting message "No Services Configured" which is dislabing VM services on that phone. Is there any way I can only disable directory services on that phone and not VoiceMail?
