Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings i have provided an internet service to certain customer , we provide him with 500Mbps speed , the logic said that the upload should be 500Mbps and download 500Mbps (Full duplex channel) but the problem here is 500Mbps splitted between the u...
Hi GroupI'm having a Cisco ISR C1111-8P Dual GE WAN Ethernet Router in my organization today i am trying to make test speed to certain server the wan interface with the PE router is 1G also the Lan interface with my laptop is 1G directly connected ...
Hi All! I had a problem which is easy to some , i have an SG350 switch topo attached below the switch connect to Panasonic PBX port gi/50 , IP phone to port gi/6 , connected to other switches from gi 1,to 5, but the phone not registering , something ...
Hi All! I 've been configuring CMS 2.8 for a customer everything registered , looks fine but the problem is when making a video call between 3 participant there is no video just audio and sometimes the conference disconnect.In the CMS logs , I rec...
Thanks Joe also i find out that someone has changed port-channel calculation formula for summing traffic in PRTG that is why i got wrong reads . and thanks for your reply which was very helpful.
Hi joseph
i apply a qos police to customer for 2.15G but when i check prtg the B.W exceed the policy and reach to 2.4G ,, it should drop traffic at 2.15 G right !
show policy-map inter x/x = (5 minute offered rate 2476238000 bps, drop rate 5220...
Hello Dear i had the same issue mac flapping using QinQ i see about 500 mac addresses flapping my customer interface also with my PE trunk port, i checked some of the mac addresses with customer all belongs to him. Any suggestion.??
Hi fellas In which case I should use vlan dot1q tag native I am having problem there is one customer alot of mac addresses coming from his interface it is like a storm of mac addresses and the port start flapping with my PE trunk port also I see no...
i see 1min different. let is forget about monitoring part , For the txload 255/255 this happened to all interfaces , is it a bug on 7600 routers i mean it is weird kind of hardware issue or bug ? Note:-i even tried my laptop it is directly connect...
