Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
We have a ucs-c250-m1 server. When i access Esxi with KVM Console, getting error like "No Signal".
Please find the Picture which i attached along with this mail
Thanks and Regards,
Nisar
Hi Guys,
I have registered 7940 CP with SCCP Protocol which is connected to Brocade Switch. But phone not getting IP. I have manually configured also,
cucm version is 10.5
switch brand : brocade poe switch
is brocade switch SCCP Protocol defaultly?
Hi Guys,
I have a 2811 ISR router. I want to configure MGCP PSTN gateway on FXO port. here i am mentioning the ios details:
Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(24)T4, RELEASE SOFTWARE (fc2)
is this fine for m...
Hi Guys,
Is there any option to lock IP Phone to prevent unauthorised call after office hours like keypad lock or user name/pin for IP Phone
Kindly suggest
Thanks in Advance,
Hi Ammar,
Thank you.
I have turned off my PC Firewall. but still no Luck.
then i have directly connected a Monitor to UCS Server. Monitor showing VGA No Signal.
Should i install new EsXi on Server?
Kindly Suggest
Regards,
Nisar KP
Hi Chris,
Now 7940 IP Phones got registered. bcoz, CDP disabled by default. Now,the customer has enabled CDP on Brocad Switch.
Thanks and Regards,
Nisar KP
Hi Chris,
Every Phones are conneceted in same vlan. i have done Factory Reset and put IP manually. but no luck.
3905 SIP phones are working fine with same vlan. getting IP and Registerd with CUCM.
Thanks in Advance
