This is a new install of a UC560. I have setup 1 paging group. When I dial the paging #, the number keeps coming back busy, After several tries paging connects. I have all the phones in the staging and absolutely no one is using the feature.Any su...
Hi,I just wordered if there is any guide explaining the meaning of each parameter showed on UC320W user.debug voice --- OBJ POOL STAT ---.Thanks in advance.
Hi everybodyI don't find how to set the local time nor ntp servers settings on my SPA 112 device.Here are model hardware and firmware characteristics:and here is the "network settings" tabI have no tabs under it:Did I do something wrong, or how can I...
Hi. I didn't find in documentation how to solve the following problem. It is necessary to execute cisco device reset with the current active calls. Sometimes suspends the voice module, but web the interface it is thus available, the device doesn't ...
Hi. I didn't find in documentation how to solve the following problem. It is necessary to execute cisco device reset with the current active calls. Sometimes suspends the voice module, but web the interface it is thus available, the device doesn't ...
Looking for some advice on the following....We have a UC560 & SMB network.I need to extend PoTs service to a remote building, to which we have no infrastructure cabling.Wondering if I can do that from the UC560, if I create a Wireless bridge to the r...
I am in the process of loading a MoH file using CCA. The customer's files are close to 40Meg!
Hi ,I tried to configure sip trunks with AAPT (Australia), bit it didn't register with sip & gave following logs. Please advice me to resolve this issue.RegardsSamJan 1 11:00:30 UC320W user.debug voice: SIP message from source IP 127.0.0.1 is blocke...
It used to be in the System tab, and used the time zone and DST settings in the Regional Tab.I bought this device recently and I cant find in the GUI the NTP settingsHere the informations:and I have no tab under "Network":and I am 9 hours away from P...
Hi,we are using UC560 for IP Telephony system and i received complain from end users about that any user know the IP address of IP phone he can access it through the web and view all call history as dialed calls or received calls.so i need to disabl...
I have SPA504g connected to my voip PBX. When the MWI option is set to yes, it turns the MWI on permanently, regardless of whether there is a message or not.The only way to turn off the MWI is set the option to NO.Any ideas why this ahhpens and how t...
Hi, I have a physical fax hook up to my FXS port 0 and a physical line to my FXO port 0. For an unknown reason when I am sending faxes now it tries to go out from a SIP line instead of goign out the FXO Port. I know the phycical line is working ...
I down loaded SPA525_Remote_SSL_VPN_with_CCA_TEL_19_sdistef1 pdf and followed instructions to set up our SPA525G2 to connect remotely. However, as I ran through the instructions, the phone didn't reboot as I expected and it didn't atomatically pull i...
Using Cisco Conf Asst I'm trying to upload a wav file into the media folder to make music on hold changes. Originally I tried remotely. Assuming being remote was the issue I went to site and connected directly. Same issue. TFTP Server on my laptop is...
Hi, I have UC 540. Every user has its own DID and if user is not there call will be forwarded to voicemail (39), after which user will receive email with the message. On the other hand there is ISDN line, and blast group. So all phones ring, and if n...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: