Hello, How do I setup my Cisco 8841-3PCC-K9 phone to call *97 for voice mail?I tried entering *97 in the web interface under Voice | Phone | General | Voice Mail Number but that does not work. I also don't see where I enter the *97, or voice mail for...
Greetings,We are an ITSP who offers customers free or reduced cost phones with contract. We move about 4000 phones/year and we are on target to move approximately 6000 phones during 2014. The phones must be securely locked to protect against tamp...
I am a new IP phone user and have a question:If a call is forwarded to another internal phone, caller ID shows only the number of the phone that forwards the call. Is it possible to show also the number of the phone that calls?
Hi. Wondering if anyone has tried TLS/SRTP with a Cisco SPA ATA or phone and this carrier? I started with this SPA112 with factory default settings, adjusted them using the Voip.ms requirements for UDP mode and it registered and made calls successf...
Hi,My Cisco SPA112 has been working great with my provider, until the new firmware released a few days ago, 1.4.1SR3. It was on SR1 previous.The new SR3 has been created it seems to fix a problem where bad actors could submit a false/bad certificate...
I have this SIP/2.0 500 internal server error. Incoming call service will normalize after power reboot. I need help on this problem.Sorry, I wrote UC520 earlier.
I am trying to set up a SIP trunk DID. The calls do no go through, when a trace is performed the SIP Trunk Provider says UC520 replying with "500 internal server error" in response to inbound call.Is this a generic message that has lots of possible s...
I'm using the SPA525G SIP with a hosted PBX (RingCentral). We have two of these phones at different locations, but both are connected via Verizon FIOS. Bandwidth is not an issue, but one phone sporadically reboots and recently has been dropping cal...
Hello, I am looking for a document or information about teleworker or similar.I have a UC540 connect directly to internet using WAN port. Now, I would like to connect a PC and phone in my home and connect them to UC540.There are a lot of documents ab...
Hi, since a few days I can no longer browse the PC via the ip phone's ethernet port. Only a PC connected directly to the UC540 switch works. Can you help me? I tried them all ..
My boss needs to know how to retrieve call logs that will show duration, the number called, and the date. Does anyone know if the CISCO IP Phone Model SPA508G has this capability? Thank you!
HI,I require the latest Software Pack for my UC560, as this unit is EOL Cisco has no files available on their web site, I was wondering if anybody in the community has the software pack that they can share.Thank You.
WHAT?Today we are announcing the release of the Cisco UC320W 2.3.3(4) Limited Deployment Firmware release. This fix release is available only via the Cloud by installing the attached Platform Modification File (PMF). This is the 2.3.2(6) firmwar...
I have prepared a 7975G with two different extensions, but I can't dial from one extension to the other. Extensions are 201 and 202. When I try to dial 202 from 201 I get a busy-like sound as soon as I press the number 2. Please advise. Sergio
I have trouble setting up my ATA Spa 122, I can not access the web settings, I have connected my PC on the same LAN, I can only enter the Web-based Utility from the Ethernet port of the ATA. You can set for example if my PC has IP 192.168.1.3 and 1...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: