Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1656
Views
0
Helpful
1
Replies

SPA8000 DNS SRV Configuration Question.

philjaeger
Level 1
Level 1

‎01-24-2012 09:33 AM - edited ‎03-21-2019 09:42 AM

I am trying to use DNS SRV records to get the proxy addresses.   We have the SRV records created and can see that the SPA8000 is getting them via a packet trace but when I make a call the DNS SRV domain gets sent in the invite and not the proxy address.  Then invite gets sent to the correct proxy host but the invite is in an invalid format or something and I get a 400 bad request from the proxy server.  

I'm not using the default SRV record name so my proxy looks like this in the SPA.    _sip_dns1._udp.domain.com.  

Proxy:  _sip_dns1.udp.domain.com

Use DNS SRV:  Yes

DNS SRV Auto Prefix: No

The invite looks like this    INVITE sip:19495551234@_sip_LO0c._udp.domain.com SIP/2.0

Is there a way to send the call with the IP of the proxy server, or something else,  in the invite?

0 Helpful
1 Reply 1

nseto
Level 6
Level 6

‎02-02-2012 05:08 PM

For actual registration, use the outbound proxy parameter.

For what you want to show in the From: for the Invite, put what you want to display in the Proxy parameter.

Be sure to set 'use outbound proxy' to yes.

0 Helpful
Customers Also Viewed These Support Documents