VPN

I'm trying to set up an ipsec tunnel at a particular site, and I am just stumped at this point.  I have two sites I'm working with, a test site on my bench and the other actual site at another location.  Both are ASA 5510's, both are running ASA v8.2...

We recently ran a Vulnerability scan for PCI compliance against our Cisco ASA 5505.  One of the issues was the HttpOnly flag.  I searched the Support Community and didn't find a solution.Can someone please help me????Thanks,Ken

hello, does anyone has already configure ASA for two-factor authentication with WIKID system ( One time password) ? i want to aiuthentication VPN Users. the WIKID system  is in the LAN. so soft token installed on users machines cannot talk directly w...

what could be cisco project related to vpn? Please guide me for my project........Thanks in advance.....

Hi,Connecting to ASA 5505 (VPN server) via a remote VPN Client (Ver. 5.0.07.0440).  Connecting works fine with no issues, however when no traffic is sent or received over the tunnel the connection disconnects with the message:  Secure VPN Connection ...

I was tasked on building a Site to Site with a partner vendor and after exchanging information such as peer address, PSK, etc, I started to build my end of the tunnel.  The way the topology is setup is that I have an 871 ISR behind a broadband busine...

Hi Expert,I configure site-to-site vpn on cisco router to secure traffic like following config.I just want to make sure it secure enough or I need to do more config.Do I need to apply any acl to outside interface to secure my lan?Thanks!crypto isakmp...

I am not sure how to resolve this issue:Cisco Systems VPN Client Version 5.0.07.0290Copyright (C) 1998-2010 Cisco Systems, Inc. All Rights Reserved.Client Type(s): Windows, WinNTRunning on: 6.1.7601 Service Pack 1Config file directory: C:\Program Fil...

I have reset the device to factory default before I upgrade to 7.1 from 6.4. The default password was both empty. After Upgrade to 7.1, I can't login, I have tried both usedid and password as "cisco", not work.Thanks for the help!

We use Cisco AnyConnect to VPN into a client's network. On our new computers (November 2013), we are using Norton AntiVirus 21.x, which does not seem to be on Cisco's approved list of antivirus software, though version 20.x is.Any insight into how lo...

Hi Guys I have a similar network to the one explained in this document http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps6659/prod_white_paper0900aecd805f0bd6.htmlMy vpn traffic is able to communicate with hosts behind my in...

I am implementing an SSL VPN service using  Cisco ASA.I noticed that my  users will need to install Cisco Portforwarder Control and Cisco SSL VPN Relay Loader ActiveX Controls in order to access Terminal Servers and Web bookmarks via  RDP and HTTP/HT...