VPN

Hi,Connecting to ASA 5505 (VPN server) via a remote VPN Client (Ver. 5.0.07.0440).  Connecting works fine with no issues, however when no traffic is sent or received over the tunnel the connection disconnects with the message:  Secure VPN Connection ...

I was tasked on building a Site to Site with a partner vendor and after exchanging information such as peer address, PSK, etc, I started to build my end of the tunnel.  The way the topology is setup is that I have an 871 ISR behind a broadband busine...

Hi Expert,I configure site-to-site vpn on cisco router to secure traffic like following config.I just want to make sure it secure enough or I need to do more config.Do I need to apply any acl to outside interface to secure my lan?Thanks!crypto isakmp...

I am not sure how to resolve this issue:Cisco Systems VPN Client Version 5.0.07.0290Copyright (C) 1998-2010 Cisco Systems, Inc. All Rights Reserved.Client Type(s): Windows, WinNTRunning on: 6.1.7601 Service Pack 1Config file directory: C:\Program Fil...

I have reset the device to factory default before I upgrade to 7.1 from 6.4. The default password was both empty. After Upgrade to 7.1, I can't login, I have tried both usedid and password as "cisco", not work.Thanks for the help!

We use Cisco AnyConnect to VPN into a client's network. On our new computers (November 2013), we are using Norton AntiVirus 21.x, which does not seem to be on Cisco's approved list of antivirus software, though version 20.x is.Any insight into how lo...

Hi Guys I have a similar network to the one explained in this document http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps6659/prod_white_paper0900aecd805f0bd6.htmlMy vpn traffic is able to communicate with hosts behind my in...

I am implementing an SSL VPN service using  Cisco ASA.I noticed that my  users will need to install Cisco Portforwarder Control and Cisco SSL VPN Relay Loader ActiveX Controls in order to access Terminal Servers and Web bookmarks via  RDP and HTTP/HT...

Hello Experts,We have a Site to site VPN set up to client and a new IP 67.22.X.X is been added over the VPN tunnel recently at both the sides. i do see successfull Phase 2 tunnel up for the 67.22.X.X but the encry/encaps are not incrementing over the...

I have change  the dchp-network-scope on an existing Cisco anyconnect group policy, but dhcp leases are still been issued from the previous dhcp scope. The DHCP sever is on the inside network  and has not changed.  A new scope was created. Nothing el...

I have an ASA 5505 given to me that I am trying to reset.Reset factory defaults and updated ASA to 8.4.7 and ADSM to 7.1.4. At this point I was still able to connect using ADSM with no username/password.Updated ASA to 9.1.3. This is the only change t...