VPN

Is there a way to set the minimum password length on an ASA like you can on a router?

Here is the setup. I am working on trying to use ASA's at "jump servers" for remote access to network devices. The idea would be to connect to the ASA via a clientless VPN connection and then connect to the network devices.My question is this. For...

Hi,I have a cisco 1721 router c1700-advipservicesk9-mz.124-15.T7.bin IOS and easy vpn server configured.I do not know why, but when I try to configure the vpn server(easy vpn server) is impossible to set sha2 or aes encr even this IOS supports both....

Here is the Error.RTR_SPOKE# Apr 16 22:16:42 [IKEv1]: IP = 2.2.2.2, Removing peer from peer table failed, no match!Apr 16 22:16:42 [IKEv1]: IP = 2.2.2.2, Error: Unable to remove PeerTblEntryMy understanding is it is a Phase 1 problem, I get the error...

I am unable to connect with the new Anyconnect VPN installation when it tries to connect, it raises an alert that says, "The Windows Routing and Remote Access service is not compatible with the VPN client. The VPN client cannot operate when this ser...

Dears,i am a little bit confused when configuring IPSec site-to-site with Nat Overload. I have two questions:1- I need to know the order of operations between NAT overload (including either an ACL or a route-map) and crypto map (including an ACL). Fo...

Hi, I have an Cisco ASA-5510 that have a lot of packet dropped in a sub interface of outside physical interface. Why do this? Is a queue-limit issue?show interface DMZ_TNInterface GigabitEthernet0/2.14 "DMZ_TN", is up, line protocol is up Hardware i...

Hello!I have a trouble with stateful VPN configuration and Cisco VPN Client.My configuration in the attach. Please check it.So everything seems ok, but when I make Cisco VPN Client connection to standby IP address I see cisco3825_1#show crypto isakmp...

Greetings, we have a client with one HQ location and three branch offices.Currently the HQ has a managed 2610 router terminating the internet connection, behind this is a PIX515 and behind that is a 2651.The PIX provides VPN client termination and se...

In my new office, we have a Cisco Catalyst Express 500 switch. I want to check its IP without disturbing any existing setup. Can somebody help me?

Hi Having a weird issue between a ASA 5505 and ASA 5520 both are running 804-K8. The tunnel will remain up for around 8 Hours then drop. It will then be down for about 30 seconds before coming back up.This wasn't a problem until we started replicatin...

Hi all,I have a case to migrate the VPN Concentrator to ASA Firewall but i have forgotten the Group Authentication Password, Is there any way / tools to recover back the password?

Can any one help me is resolving issue. I have a vpn tunnel which is up and working.I am using static nat host to host and I want a whole subnet will point to a single IP( which is visible from other side and its part of the VPN tunnel traffic ) can ...

hi,I need assistance in configuring Site to site VPN with one end as PIX Firewall and another End with RouterLAN---PIX-------((INTERNET))-------RTR----LANEncryption is 3DES and MD5Need to allow 3host on each siteSite A need to allow 192.168.1.125 / 1...