VPN

Hi, I have a weird problem with our Branch to Branch VPN. Please find details below 1. Details: * Site 1 wants to use a oracle web based application hosted at Site-2. VPN is set and both the sides can ping each other but Site-1 cannot access the orac...

I am trying to send messages to a central syslog server via a VPN tunnel. I can't ping the Syslog server from the ASA and no messages are sent.I believe I may need to do something to allow traffic generated on the ASA to make use of the tunnel. I'm...

I'm not sure if this is the best area to post this question, but...I have several routers in a lab (for CCNP and CCIE study) connected to a DECServer 90M via console port. With this setup I can telnet to the DECServer's ip and specified Listener por...

Hello,We just got a UC520 for our small office. I am trying to set up a VPN (which is totally new for me). The VPN should be used from home on a pc with Cisco VPN client installed and should connect to the UC520 in the office and and get an ip addres...

I migrated remote users from MS PPTP to Cisco Client VPN 2 month ago. Eversince this was done, it has been nothing but long lockups, freeze, disconnects and crashing Citrix sessions. Prior to migration, all connections were coming through a PIX 520 t...

I've been tasked with setting up a VPN from a static IP on an 1841 router to a dynamic ADSL connection on an 1801 router. I need to setup a site to site VPN as well as make the 1841 accessible for remote users from client VPNs. This will be a first...

I'm trying to set up dial on demand routing between (2) cisco 1841 routers with PPP authentication. Both routers have a modem connected to the AUX port and both modems are connected to a POTS line. I want both routers to be able to initiate a call. C...

Greetings,Forgive me if this has been discussed before.I have an L2L between an ASA5520 and 871 on static IPs. For some reason, I cannot get the tunnel to form from the ASA side - but can trigger tunnel formation by issuing pings from the 871 - usin...

Can a router be a key server and a group member at the same time ?Many thanks

I have an ASA that currently has about 100 IPSEC tunnels coming into it. NAT-T is not enabled on the ASA. We have a new customer coming on that is asking for us to enable NAT-T as apparently they have a NAT device on their side in between. My questio...

Hi,In the Cisco ASA 8.0 Command Reference it says that "show icmp" can be used to display the ICMP configuration, but it is not available (at least not on our 5540s):ciscoasa# show icmp ^ERROR: % Invalid input detected at '^' marker.cisco...

I have an ASA configured for SSL vpn for remote access, and also an IPSec tunnel between the ASA and another site. The SSL vpn works fine, and i am able to access everything at the ASA site. The IPSec tunnel is also working and i am able to comm...

Recently my company upgraded IOS on several hundred Cisco 2651XMs from 12.2.37 to 12.3.22a and we started having problems with some 50+ sites still on ISDN BRI as backup. We use dialer interface as multilink PPP logical interface. So on actual BRIs o...

HI All, Can i please get help in regards to following issue I have 1xWeb Server in my inside network with an IP address of 10.90.30.166. Initially i had setup NAT translation as #ip nat inside source static 10.90.30.166 rrr.rrr.rrr.rrr #ip nat inside...