VPN

Hi All,PIX pair with Active/Stdby mode configured for Stateful failover stateful cable & ethernet interfaces connected via Xover cable.It is observed that, the the Stdby PIX memory utilization is above gradually increasing (from monitoring system dat...

Does anyone know how much of the total throughput is used by the encryption when using the tunnel?Thank you,Ilene

Why is it not possible to configure tunnel protection on a Router configured to do both DMVPN and GRE VPN using a WAN Interface as Tunnel Source for both DMVPN and GRE VPN Tunnels?

Hi,I have deployed an a VPN IPSec with ASA 5505 behind router non-Cisco and WAN ADSL for connect Lan to Lan network in my enterprise.All it seems works in order and in practice I don't lost any packets but every so often some application TCP (like VN...

Hi,I have a Cisco ASA 5520. I've added a few borkmarks but can only get them to work over clientless SSL VPN by using the IP of the web servers.Can I use the DNS names? I have 2 internal DNS servers.I am using the ASDM, but can use CLI too.Thanks

What troubleshooting steps can we performed if Anyconnect Client is unable to access the Local LAN after establishing a tunnel to the ASA. Pointers to any troubleshooting URLS much appreciated.

I have a requirement to setup an IPSec VPN between two peers using manual keying.Network is as per the attachment;The local peer is 10.0.1.2 but seen as 185.0.1.5 by the remote peer. 185.0.1.5 is actually assigned to a host but this device is not inv...

Hi AllI am new to the CISCO ACS software ,at present our vpn clients are being authenticated using the cisco acs My problem is when they get connected they are being assigned with a subnet mask and gateway can any one help me to find out where it is ...

Hello,The speedtouch modem connected to the internet and the LAN side has 10.0.0.0/24 with 10.0.0.138 as LAN interface ip address. The pix firewall connected behind the speedtouch with pix outside ip is 10.0.0.137/24. Pix inside is LAN network with 1...

Hi i have set up an easy vpn server on cisco 1841 running Adv.IP Services 12.4.20.TThe router has 2 adsls and they are configured for load balancing. There is no def.gw configured. Instead, the ppp ipcp route default command exists in both dialer int...

Hi all, following some instructions i found on the web, I managed to get remote access into my soho 877 router today, However I would like to understand the commands used, Can anyone please comment next to the config what the commands actually mean.c...

I faced an issue of accessing site site vpn through remote access. the senario as follows:-i logged into my private network through remote access vpn but I cannot access site to site vpn through it. I tried alll the options .. any one can guide me......

I have 3020 vpn concentrator with 4.x IOS. I am not able to acces this concentrator on its publich IP. I have enable the publich management access, webvpn access. I have even so mnay times disable and enable the public interface, reboot the concentr...

Hi everybody,I'm try to work with WEBvpn on my ASA 5510-k8 (ASA version 7.2.1, asdm 5.2.1).The url I'm using is this : https://out_ip_addressWEBvpn is up (i can monitoring it) with user tec110pf, IP=myipclient, policy=mypolicy,tunnel-group=defaultWE...