VPN

Hi folk,I have a sitution that a user of our parnter company need to access our netwrok via VPN connection.The setting:User has Winodow 2000 laptop wiht Cisco VPN clinet 3.5.1 install on the machine. The laptop is siting behind one of the WatchGuard ...

Is it possible to use the default w2k/xp VPN connection with this device, rather than installing the CISCO client ? I am having some trouble configuring the xp client and the 506e shows no activity unless I set the XP client to have a "pre-shared key...

Got an old Novel server running IPX only. CEO wants remote users to be able to VPN to network with existing PIX 506 and do data entry on Novel server with IPX through the VPN. Can this be done? With GRE? I already have the client to PIX VPN workin...

We would like to limit which IP (public) addresses can establish an IPSec tunnel to our network. One reason (to help clarify) - if a laptop is stolen and the password is discovered - you still must have a certain IP address or subnet for the tunnel ...

Hi,I have 2 identical Macintosh Titanium PowerBooks. Both are running Mac OS 10.2.6 and Cisco Systems VPN Client v3.7 (REC), using an ATT Worldnet dial-up connection.One can connect via VPN to the VPN 3015 Concentrator, while the other gets a "Remote...

Hi We are using Cisco 3015 concentrator and cisco vpn clinet 4.02, and it's working fine for ftp, telnet, ping to Citrix server with vpn client, but when starting Citrix client to connect server, get error " unable to contact the metaFrame server bl...

hi,I'm new to cisco and I just got this thrown in my lap. I need to establish an endpoint to endpoint tunnel between our remote router and HQ pix. I configured everything according to plan but nothing is working. Am I supposed to intiate the tunne...

Hello,We are having a problem with our pix not accepting VPN Client connections.We have recently upgraded to 6.3 and enabled the 'isakmp nat-traversal 20' feature. Its works with UDP encapsulation and has been working for about a month now. But all o...

Hello,I have a customer that is considering the use of WiFi wireless technology to extend their office environment to an adjacent building. However, the technology used to extend the segment may or may not stay WiFi, and could be replaced by optical...

Hi All,How can I load balance (per destination) across two IPSec VPNs? My main site is dual homed to the Internet w/ two routers (one router per ISP). The remote sites have either a single router or a single PIX. I would like to run GRE over IPSec wi...

I've got a 3640 router with 2 dialer interfaces configured with PPP to fire up an ADSL modem (each interface has it's own modem, so 2 in total). Everything was working perfectly until I upgraded the IOS from 12.2 to 12.3-1a. Now the router will onl...

Hi!I've installed a CA to authenticate VPN client remote users. After installing the CA's certificate and the request and installation of the identity of the VPN 3005, I did logout and the certificate disappeared when i did login the check it. It see...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

Could some one explain the following error?<<<ISKMP OAK INFO (NOTIFY:INVALID_COOKIE) VPN version 3.5 running on a MAC

We would like to limit which IP (public) addresses can establish an IPSec tunnel to our network. One reason (to help clarify) - if a laptop is stolen and the password is discovered - you still must have a certain IP address or subnet for the tunnel ...