VPN

Hi All,I'm new to Cisco so a little help would be great.I just purchased an Cisco 806 Broadband Router. I've added the Firewall/3Des IOS to this router.Before the upgrade I was able to use the Cisco VPN client from a Windows PC to connect to my offi...

I have setup the PIX to allow IPSec clients and I am able to connect to the PIX but I cannot access anything on the inside network. My config is:access-list 101 permit ip 171.16.1.0 255.255.255.0 172.16.2.0 255.255.255.0ip address outside x.x.x.x 255...

Can someone help build a config on a 827 adsl router, for Win 98 or Nt clients (with vpn client 1.1) or Windows 2000 clients to create a vpn tunnel with a preshared key?ThanksBruno

Hi!Does anyone know why the PIX stops VPN traffic when in TCP transparent tunneling mode? What is the technical reason for this? I am very curious why this is the case....It seems that the PIX needs to have ESP 50 and UDP 500 open either way (trans...

Hi! How does one VPN out from a 'behind the corporate firewall' scenario to a remote network? I found out that IPSec VPN uses ESP 50 and UDP 500 protocols and that if using transparent tunneling mode it can either encapsulate ESP 50 in UDP 500 (UDP) ...

Is it possible to use VPN 3002 Client running V 3.5 software in Network Extension mode with PIX running V 6.1(1). If Yes, is it possible to enable each user to be prompted for their credentials when they access the remote network? Any ideas?

Does L2TP SUPPORT NAT ?

I have an IOS router (1710) that needs to get its Wan IP address from the ISP via DHCP. Since I do not know what IP address I am going to get, how do I define the default route?I have tried:ip route 0.0.0.0 0.0.0.0 eth0 but I am never able to ping th...

Can someone tell me how many clients the 506 VPN can handle or point me to the correct website please.cheers for any help.Andy

I was just wondering what importance does the secret key have...i.e what could happen if a non authorized person found out. What kind of damage could be done.(I am putting this question in reference to Cisco AcS3.0 and cisco networking devices.)

I want to VPN to my company's internal network from home. At the company end is a VPN 3000 Concentrator. However, at home my PC connects to the Internet through another machine running Microsoft's Proxy Server; using Winsock Proxy for normal TCP conn...

I forgot what the commands are that you need to have in the firewall for the newest vpn client (3.1) to work. I know that you have to put these in:vpngroup xpclient address-pool clientpoolvpngroup xpclient idle-time 1800vpngroup xpclient password pas...

I have setup IPSec on a PIX 515 running 6.1(2) exacly as the documentation states. I can connect to the PIX using VPN Client 3.1 but I am not able to connect to or ping anything on the inside network. Below is my PIX config:access-list 101 permit ip ...

HelloI need to open a vpn tunnel between a VPN client and a concentrator, the problem is that the client resides on a token ring Network.I read that token ring NIC will not be supported anymore, but I would like to know if there is a possibility to u...

We have a few users that require the ability to create an IPSec tunnel to a partner site. All our users sit behind our PIX 501.When they try to use the client to connect, there is a socket error 10048. I assume this is because of a port that I need t...