VPN

hi all,   i have DMVPN setup hub and spoke the vpn is working fine. currently i got one requirement from spoke only one external webserver ip need to go via tunnel. how i can do that. i tried add in the ospf network in the HUB site but its not advert...

Hello, I have configured a GRE over IPsec VPN (Hub and Spoke) between HQ and 3 remote sites and used EIGRP as routing protocol. One of the 3 remote sites, the tunnel is not establishing. I have used debugging on that spoke router and got the followin...

We have users in the UAE who until recently had been using Anyconnect with no issues. Within recent weeks they are having major connection issues and when the VPN does work, they are getting extremely slow speeds across the vpn, sub 500k. Speed acros...

Hi    Kindly advice possibility for configuring one site with dyndns  address (any firewall)  and other side with Static IP (ASA5585)    Read Below documentation from cisco for Dynamic IP address .But its less secure as any one with same pre-shared k...

Good day Experts   I have 7 sites connecting to one site they are different vendors accessing some services in my network. They will all come via internet.   I have a dual ISPs and i want one to be a back up. My perimeter device will be a Cisco ASA 5...

Hi, I'm using Cisco AnyConnect to connect to my job vpn. Today it has already worked, but in the last half hour it repeats "Connection attempt has timed out. Please verify Internet connectivity" and I have changed nothing and of course my Internet co...

Hi All ,    I am looking to build  multispoke tunnels on an ASA so they are able to reach each other .  I am wondering if I am able to NAT 5 subnets to a single IP and allow this through the tunnel ?    Any additional subnets added will then sit behi...

Seen a lot of posts on this topic but haven't found a solution that works for me with this specific error. I fixed all the other errors with this cert (name mismatch, not trusted source) but can't get this "Certificate is not identified for this purp...

Dear All,   We have deployed ASA Firewall with version 9.6.3 with Any connect APEX license .We have deployed any connect VPN successfully using manual installation from client PC.   However , we are not able to get the prompt for web lunch when we ...

Hello  I need to remove the Hairpin traffic to make it straight. What are the considerations I should consider to remove this type of traffic. ?    

Getting the following error when trying to NAT a local subnet and then send through a VPN to the remote subnet. If anyone has any insight into this, it would be greatly appreciated. See below for the configuration. I've removed what I believe to be u...