When I did my testing using DX80 and SX80's, Video Mesh Node displayed the call status as 2 calls for one Point-2-Point call.
For two simultaneous Point-2-Point calls, it displayed the call status as 4 calls.
My assumption is that each endpoint connection to the Video Mesh Node is treated as Call. In the Cisco Webex Video Mesh Deployment Guide, the headline of the topic says Call Capacity on Webex Video Mesh Node Platforms. So baseed on this:
Scanario1 -
100 (up to 720p) --> 100 simultaneous connections to Video Mesh Node at 720p.
35 (up to1080p) --> 35 simultaneous connections to Video Mesh Node at 1080p.
Scenario 2
65 (720p) --> 65 simultaneous connections to Video Mesh Node at 720p.
28 (1080p) --> 28 simultaneous connections to Video Mesh Node at 1080p.
Also note that the capacity of a Webex Video Mesh node in a cluster can vary. Factors that influence the capacity are the type of devices and clients in a meeting, resolution, quality of network, peak load, deployment, and so on.
Please rate helpful posts and if applicable mark "Accept as a Solution".
Thanks, Vaijanath S.