Wireless - Small Business

Dear Community Iam kind of annoied right now. For the last 10 years it was easy for me to setup Cisco APs for customers.The setup was always the same. Two VLans Routed on the Router with DHCP enabled on the Router, a trunk to the Accesspoint, two SSI...

Question is in the title, but can the subordinate AP reach out and connect to the AP controller wireless or does it demand that it has to connect over LAN connection?

Please be advised, the automated software distribution services will no longer be available from March 1st (2022) forward. The following devices are affected: RV260/RV160 seriesRV34x seriesCisco Business Wireless (CBW) access points There is a simple...

I assume it happens after kernel: [41820.446622] wl0: fatal error, reinitializing kernel: [41820.446607] wl0: Fatal error: Big hammer due to increasing rxanyerror kernel: [41820.384108] br-vlan1: received packet on wl0 with own address as source addr...

Having issues updating my software. Unable to do this on mobile app and also on online portal via HTTP. Error: ImageReq to AP FailedRetry attempts +15 Logging:*spamReceiveTask: Feb 16 13:55:21.195: %APF-3-MESH_EXTENDER_AUTHORIZED: spam_radius.c:288 W...

HI all.  When I  am turning connecting up a new CWB240AC onto the network, the mac address is automatically being added to the allowed MAC list.  I am not adding it myself.  How do I stop this? AP's should not join unless I have added the MAC address...

I have  CBW 240 AC Access point and it shows me operational status is down It was working earlier I just increased the 5GHz channel width from 20 to 40 but I reverted back. Still I am unable to see the SSID. Any help? 

This has been an ongoing struggle with the WAP-150 since I installed them.   I have 2 units with a single-point setup.  The 5 GHz disappears and the 2.4GHz has connected the clients, but the client has no LAN or Internet connection.   Seems to happen...

I have two AP's CBW145AC and I need to connect them to each other wired, with the primary supplying data and power wired to the second, which is in another room. After installation and configuration, the second ap does not appear on the network and o...

Hi,Cisco WAP121 suddenly get message that Acess point temporaary full. I have to restart the Acess point every interval then user get connect.  

Hola! buen día.   Quisiera saber donde puedo consultar si uno de nuestros equipos cisco, en este caso un Access Point WAP581con serie: DNI2409A019.    Se adquirió en México. Esperando nos puedan apoyar.Gracias de antemano, saludos. Ya recibí respuest...

I have two brand new WAPs, 240AC & 140AC. Using a browser with an IP address, I can go thru the start page, setting up a user, static IP address and Wireless SSD/Passphrase.  When I click the "Apply" button, I get the 'Reboot' message then I get this...

Hi. I have an 861 with a wireless sub module. Is it possible to set this up as a simple access point, disregarding the router?;) Any pointers as to how i can do this?