Wireless - Small Business

Hi,we have got 3 Cisco APs 541N with firmware version 9.2.2 and want to set up the cluster function for those APs.Here is the problem:Before enabling the cluster you can ping all three APs located in the same local network with a delay of 1ms or belo...

Antennas were set aside prior to device installation, and now can't be found. Can they be ordered as a replacement kit?

Hi,I just installed a WAP321. I literally configured a test SSID, implemented WPA Personal security, and could not get an iPad or Blackberry to associate with the network. The error message that appears in the Blackberry is "EAP Authentication Failed...

Please I need some help to set my wireless network with those equipments.I have the E4200 with RE1000 in my old place, with no problems. In my new place, there is a blind spot and I bought another RE1000 to use like a repeater of the first repeater (...

Hi All,I just got a WAP321 to replace a very frustrating WAP4410, does anyone know the SNMP OID to obtain associated wireless clients for each of the SSIDs ?  I'd be happy with any OID for client numbers so total clients associated will be fine.Many ...

I have been trying to find this information, but can't seem to locate it. Does anyone know the answer?Thanks

Dear community,We are running  WLAN using WPA2-enterprise with AES & IAS server.Mostly we are using AP's 1131 and Cisco WLC 4400.I added on a new location 2 AP 1142G and since the installation I got 3-4 clients having regular disconnections...Basical...

Hi, I recently bought a Cisco RE1000 wireless repeater to boost the  wireless signal to my garage office. Since then the signal has been  intermittent, fluctuating between strong and weak signals, sometimes  dropping off completely. Today I finally u...

Dear, I would like help from you, because I have a problem and I can not detect. I have six devices installed in the WAP model 4410N on two different floors, and a third on each floor. Both are with the same SSID, but when I'm walking him on a quest ...

Hello, allI need to use the Radius in WAP121, but I found there is no field to change the port, only the field to input server's IP.The default port for Radius is 1812/1813, but my server is in our head quater and the port is the old port 1645/1646.T...

After doing a pre-sales chat with Cisco rep about my needs and budget he suggested the WAP321 and I purchased 4 and a Cisco POE 8-port switch. I have all 4 spread accross the building (small hotel with restaurant). Each is wired with power and data v...

                Hi Support;                I purchased a Linksys WAP200E Wireless-G Exterior Access Point – PoE and a HGA9N (9dBi) High Gain Omni-Directional Antenna through CDW Canada about three (3) years ago in April/2009. The first year it worked...

Hello,I just purchased a WET200.  I understand it will transmit on one antenna and receive on two antennas.  With this WET200 I observe only one antenna will receive.  If I disconnect the left antenna and do a site survey, the various signals are exc...

I'm a tech at a local business in my community and I was brought a WAP200 that was giving a client some issues. I've been told the first thing to try is to update/reinstall the firmware. I have the newest firmware file downloaded and saved, and I hav...