02-08-2011 08:58 AM - edited 07-03-2021 07:47 PM
Is it possible to activate one of the two radio's in the 1250 access point, and use the standard PoE from a switch port? I have tried shutting down one radio. I have tried the command power inline negotiation override. On the access point.
On the switch, I have tried power inline auto, and power inline auto max.
Nothing has worked so far.
02-08-2011 09:08 AM
Hi Scot,
Please remove the A radio module and see if you are able to power up just the one radio with POE, the That the G radio will be in Full power mode..
lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull
02-08-2011 01:21 PM
For autonomous IOS, upgrade your IOS to 12.4(10b)JDA3 or later and you can use BOTH radios at 15.4w (but at a lower MCS rate).
For LWAP/CAPWAP, upgrade to 6.X or later. (I know, I know, I know. I am NOT going to recommend anyone to upgrade to 5.X!)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide