Autonomous To Lightweight Mode Upgrade Image 1042

[Patrick Mostad]

Hi,

I have two AP1042 that I want to convert to lightweight, but I'm not able to find the software for that. I can only find the IOS software. Is it possible to convert? Is it located some other place?

Regards,

Patrick

[Surendra BG · Accepted solution]

Hi,

Here is the link to download the image..

http://www.cisco.com/cisco/software/release.html?mdfid=283445229&flowid=17961&softwareid=280805680&release=12.4.23c-JA2&rellifecycle=ED&relind=AVAILABLE&reltype=all

Please dont forget to rate the usefull posts!!

Regards

Surendra

[Patrick Mostad]

Thanks Surendra, I didn't look at all the images.

[Surendra BG]

ha ha Not a problem!!

Regards

Surendra

[Patrick Mostad]

Since the AP uses the same software as 1142, I already had the right version, but I think it should have been a note on the download page fo 1042.

[Vikas Gundu]

Hi Patrick,

Even im facing the same issue.

I have AIR-AP1042N-N-K9 can i convert it into lwapp.Please do suggest.

[Scott Fella]

Vikas,

You can convert any of these AP's from autonomous to lightweight and vice versa.  The requirement is that you need to be able to download the image.  If you have the support to download, then you can follow one of these instructions:

Using a TFTP Server to Return to a Previous Release

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918

https://supportforums.cisco.com/docs/DOC-18268

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918

http://www.youtube.com/watch?v=QQ_NuxdRhQ4

https://supportforums.cisco.com/docs/DOC-14960

Please rate helpful post and Cisco Support Community will donate to Kiva

Scotty

[Vikas Gundu]

Hi Scott,

Thank u.....