Wireless

When users connect to my companiees wireless, which authenicates using a Windows 2008 RADIUS server, they're prompted to accept a server certificate. I'd like to install a trusted SSL and prevent users from having to accept a cert every time they con...

I would like to set up a 5760 controller with a guest login portal (webauth) and limit the number of concurrent logins to just one for any given user.I see a lot of documentation and discussion about how to do this on the Airespace platform but not f...

HiI got a message but I couldn't understand the problem. All assistance will be greatly appreciated. Syslog message generated from device : *%CAPWAP-3-INVALID_RET_CODE: 1 wcm:  Invalid result code 3. Failed to Process DTLS packet RegardsAngela

For the outdoor AP AIR-CAP1552E-C-K9 which controller support . 

Hi,it's possible to somehow increase the sticky cache? 9 APs is not enough.STICK_CACHE_SIZE_EXCEEDED: Sticky cache can't be supported for 9th AP.Client MAC 44:2b:03:55:f4:c0.ThanksK.

Can Prime observe and monitor autonomous Bridges?I have 19 Bridge pairs, mostly 1410's, some 1310's and few 1232's I would like to have stats on..I tried a device discovery of a pair which completed successfully but I can't find the results.. Anyone ...

Hello, in  my WLC, in Controler, Interfaces, i have  10 interfaces (with 1 VLAN per interface) which are created, however, only one is 'Dynamic AP Management' Enable: the management interface.None of the other VLAN are routed to this WLC, i was wonde...

I was getting the following error for softtoken "check the key phrase field for input errors"  even i was entering the right key phrase.

Hi .. I keep getting alarm errors in Prime 2.1."Access point 'AP01' associated with controller 'WLC-01'draws low power from Ethernet. Failure reason: 'The AP draws 15.4watts from Ethernet'.Prime is running version 2.1WC is a 8500 running software ver...

The document for "Internal Web Authentication for Guest Access on Autonomous APs Configuration Example" is out of date.  Does anybody know if a new version has been created?   

I recently purchased this AP used for home use.  I wanted an AP with A/B/G/N.  When I look at the Cisco Sales Page, http://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1250-series/product_data_sheet0900aecd806b7c5c.htmlIt clearly states...