Wireless

I am setting up a 2504. I would like to set up 1 WLAN to connect directly to an ISP switch to use as a PUBLIC network. I configured port 2 on the 2504, set up interface with an address, then created a WLAN and SSID. (Port 1 is set up as internal and ...

Hi802.11a Band status which data rates should be mandatory and which should be supported802.11b/g which data rates should be mandatory and which should be supported any advices to improve wireless performance and coverage thanksCP  

I need to see if a file is on the 5508 wlc.  What is the command to show the contents of flash? Switch = sho disk0:

Hello.I have 5 APs 3602E. They are all enabled for a/b/g/n standards. When I check client statistics I can see different clients using 2.4nGHz protocol and 5nGHz protocol. But if I take radio analyzer I dont see any 5GHz networks available((( Moreove...

If I have ssid under radio0 (2.4GHz) and the same ssid under radio1 (5GHz) and connect a dual-band laptop or smartphone to the ssid, how do I know which radio it's connected to? interface Dot11Radio0 no ip address no ip route-cache ! encryption vlan ...

I am trying to find a way to set the "location" information in the WAPs that are connected to the 5760. When I try to make the changes manually via the web interface, the changes don't stick. I have not found out how to make the changes via CLI. Any ...

Hi ,I'd like to know when will the new IOS release that can make AIR-CAP3702I work in Autonomous mode ?ThxS Hasan

I mistakenly gave a controller 2 licenses when 1 was needed (need 7 in total). I had licensing rehost both. I am not able to download the 1 license for my WLC in question. I enabled the eval and rebooted. I am still not able to delete the original 8 ...

Hi tech support,I already have two WISM2 running active/standby. Now i want to separate two WISM2 to active/active. May i know any document related to this? And any impact (reboot) after the change ? Keith Chan

Are there known issues with the Cisco Aironet AP (1602 or 2602) in Workgroup Bridge mode connecting to a Enterprise Network?

  hello I have a block unknown source is found, occasionally, a few access points This block requires us to reset the AP via the remote controller. I have the following messages displayed at our WLC. Invalid addr orphan : ipv6_net.c:765 Invalid ipv6 ...

We have 2 wlc 4002 controllers and are using WCS 4.2.110.0.Over the nigth, we got a problem with several b-clients that will not connect. They shows as "probing" and with "unknown" as WLAN Profile. G and A clients connect fine.Any tips?JFolkestad

I have a UC 540 and access point AP321 for wireless infrastructure. When IP Phone 7925G i want to connect with UC540 through AP321 it doesnot come on the network. but when it will connect through UC540 wirless SSID it works fine. Can anyone please he...

I need an assistance of Cisco TAC engineer.My customer has found a problem in CUWN deployments where Cisco Virtual Wireless Controllers are being used with Cisco 1242AG access points.These APs ignore vWLC QoS profile configuration and apply SILVER Qo...

I recently purchased a Cisco MSE 3355 with locator licenses. I have 2- Cisco ISE's and 2 - WLC 5508s.Is it required to use Cisco Prime in order to see the location services that the MSE is providing?If so, what type of license do I need?